ARAGNA TECHExperience. Integrity. Clarity.

Insights · Oxygen systems

Which regulations govern aviation oxygen cylinders?

An aircraft oxygen cylinder answers to two regulators at once: the FAA for the installed system and DOT for the cylinder itself. Here is how the rules fit together, and why it matters in a failure investigation.

Shaun Hogan & Alexis Dubois, PhD · November 2026 · 5 min read

When an aircraft oxygen system is involved in an incident, the paperwork usually cites the FAA rules. That covers the aircraft. The cylinder in that system is also a high-pressure vessel, and it was designed, made, filled and requalified under a separate set of rules that often decide the technical questions.

1. The aircraft side: FAA, 14 CFR

For transport category aircraft, the oxygen system requirements sit in 14 CFR Part 25, sections 25.1441 to 25.1453, covering oxygen supply, distribution, dispensing equipment and the protection of oxygen equipment from rupture. Maintenance, overhaul and the records that go with them fall under 14 CFR Part 43. Regulators, masks and similar components are typically approved under FAA Technical Standard Orders.

2. The cylinder itself: DOT, 49 CFR Part 178 or a special permit

The cylinder is made either to a DOT specification in 49 CFR Part 178, such as DOT-3AL seamless aluminum or DOT-3HT seamless steel (a specification written for aircraft use), or under a DOT special permit, which is how many composite cylinders are authorized. Some composite cylinders are instead made as UN pressure receptacles to ISO standards under 49 CFR 178.71. The specification or permit number marked on the cylinder identifies both the rules it was made to and, for a special permit, the manufacturer. A clear photo of that marking often settles who actually made the cylinder.

3. Filling and transport: 49 CFR Part 173

Part 173, starting at section 173.301, sets the general requirements for filling and shipping cylinders of compressed gas, including oxygen. A special permit can add its own conditions on top.

4. Requalification: 49 CFR Part 180

Under 49 CFR Part 180, Subpart C, cylinders must be periodically requalified, usually by hydrostatic retest and visual inspection, by a requalifier authorized by DOT, who marks the cylinder. Composite cylinders under special permits often have a limited service life, for example 15 years, and requalification intervals set in the permit. The retest marks and records show whether the cylinder was in service legally at the time of the event.

5. Oxygen compatibility and cleanliness

High-pressure oxygen ignites materials that are safe in air. Valve seats, seals and lubricants are assessed for oxygen compatibility under standards such as ISO 11114 and ASTM G63 for nonmetals and ASTM G94 for metals, with ASTM G88 covering system design. Cleaning for oxygen service is covered by standards such as ASTM G93 and CGA G-4.1. After any overhaul, the cleaning record matters as much as the parts.

What this means in a case

  • Identify the cylinder manufacturer and the specification or permit from the label, before assuming who designed and made it.
  • Pull the requalification marks and records, and check service life against the permit.
  • Check the overhaul and cleaning records of the valve and regulator.
  • Compare valve and regulator materials against oxygen compatibility standards.
  • Keep fire origin and cause with a certified fire investigator, and the cylinder questions with a pressure vessel expert.

This is a general overview, not legal advice. Regulations and permits change; always check the current text and the specific permit that applies to the cylinder.